Raspberry Pi Zero Hat
Los 10 mejores productos de octubre de 2025
Última actualización:
9 de octubre de 2025
Waveshare
Waveshare UPS Hat (C) for Raspberry Pi Zero 5V Uninterruptible Power Supply Multi Battery Protection Circuits(Battery is Not Included)
Envío gratis
99
CALIDAD MÁXIMA
VER EN AMAZON
Amazon.es
#1 GANADOR
▼ Mostrar más
▲ Mostrar menos
Power Your Pi Zero Seamlessly From Power Connection OR The Backup Batteries. Supports Recharging And Regulated 5V Output At The Same Time, I2C Monitoring.
Onboard spring pogo pins for connecting with Raspberry Pi Zero series boards. Li-po battery recharge chip, with dynamic path management, more stable power supply.
Voltage boost chip, providing regulated 5V power output. I2C bus communication, monitoring the battery voltage, current, power, and remaining capacity in real time.
Multi battery protection circuits: over charge/discharge protection, over current protection, and short circuit protection, more safe and stable.
Recharging indicator for monitoring the battery operating status.
28,99 € EN AMAZON
Waveshare
RS485 Can Hat para Raspberry Pi 4B/3B+/3B/2B/B+/A+/Zero/Zero W/WH, Permitir la Comunicación a Larga Distancia a Través de la Función RS485/CAN
Envío gratis
96
CALIDAD SUPERIOR
VER EN AMAZON
Amazon.es
#2
▼ Mostrar más
▲ Mostrar menos
RS485 CAN HAT for Raspberry Pi 4B/3B+/3B/2B/B+/A+/Zero/Zero W/WH, with standard Raspberry Pi 40PIN GPIO extension header
CAN function, onboard CAN controller MCP2515 via SPI interface, onboard transceiver SN65HVD230
RS485 function, controlled via UART, half-duplex communication, supports automatic TX/RX control without programming, onboard transceiver SP3485
Onboard TVS (Transient Voltage Suppressor), effectively suppress surge voltage and transient spike voltage in the circuit for RS485 transceiving, lightningproof & anti-electrostatic
Reserved control pins, allows to work with other control boards, comes with development resources and manual (examples in wiringPi/python)
19,52 € EN AMAZON
Waveshare
Waveshare USB HUB Hat (B) For Raspberry Pi 4B/3B+/3A+/2B/Zero/Zero W/Zero WH with 4X USB 2.0 Ports Support USB 2.0/1.1
Envío gratis
95
CALIDAD EXCELENTE
VER EN AMAZON
Amazon.es
#3
▼ Mostrar más
▲ Mostrar menos
Extended 4x USB 2.0 Ports, Suitable For Raspberry Pi Series
4x extended USB ports, compatible with USB 2.0 / 1.1
Pogo pin design, for direct connecting with Raspberry Pi Zero/Zero W/Zero WH
USB HUB connector, for connecting with Raspberry Pi 4B/3B+/3A+/2B through USB cable
13,99 € EN AMAZON
Freenove
Freenove Breakout Board for Raspberry Pi 5 / 4B / 3B+ / 3B / 3A+ / 2B / 1B+ / 1A+ / Zero 2 W/Zero W/Zero, Terminal Block Shield Hat with Pin Header, GPIO Status LED
Envío gratis
88
CALIDAD DISTINGUIDA
VER EN AMAZON
Amazon.es
#4
▼ Mostrar más
▲ Mostrar menos
Compatible Models: Raspberry Pi 5 / 4B / 3B+ / 3B / 3A+ / 2B / 1B+ / 1A+ / Zero 2 W / Zero W / Zero (Note: NOT compatible with 500 / 400)
GPIO Status LED: LED on if GPIO outputs / inputs high level, LED off if GPIO outputs / inputs low level
Independent LED: The status LED is driven by the chip instead of the GPIO so the GPIO will not be affected
Terminal Block and Header: Connect to all pins of Raspberry Pi's 40-pin GPIO header, 2.54 mm (0.1 inch) pitch
Pin Name: The BCM numbering name of each pin is printed next to it
11,95 € EN AMAZON
IBest
Ethernet/USB HUB Hat for Raspberry Pi 3 B+/3 B/2 B/Zero/Zero W/Zero WH/Zero 2 W Expansion Board, 1x RJ45 Ethernet Port,3X USB Ports Compatible with USB2.0/1.1
85
CALIDAD FIABLE
VER EN AMAZON
Amazon.es
#5
▼ Mostrar más
▲ Mostrar menos
This is a Ethernet / USB HUB HAT for various versions of the Raspberry Pi, including Raspberry Pi 3 Model B+/ B, 2 Model B,and the size of the board is designed to perfectly fit the Zero / Zero W / Zero WH.
The Raspberry Pi hub HAT provides more USB capability to your Pi, plus a RJ45 Ethernet port, which is great when you need a stable wired Ethernet connection.
3x USB ports, compatible with USB2.0/1.1
1x RJ45 10/100M port, based on the RTL8152B Ethernet chip
Onboard multi indicators, for monitoring the status of power, Ethernet, and each USB port
18,99 € EN AMAZON
Waveshare
Waveshare Motor Driver Hat for Raspberry Pi Zero/Zero W/Zero WH/2B/3B/3B+ I2C Interface Drive Two DC Motors DIY Mobile Robots
Envío gratis
81
CALIDAD BUENA
VER EN AMAZON
Amazon.es
#6
▼ Mostrar más
▲ Mostrar menos
The Motor Driver HAT is designed for Raspberry Pi, controlled via I2C interface, will drive two DC motors at the same time. It's an ideal choice for you to DIY mobile robots.
Raspberry Pi connectivity, compatible with Raspberry Pi Zero/Zero W/Zero WH/2B/3B/3B+ I2C controlled, by setting 5 address jumpers, it is stackable up to 32 this modules
Onboard PCA9685 chip, provides 12-bit hardware PWM to adjust motor speed Onboard TB6612FNG dual H-bridge motor driver, high efficiency, low heating
Integrates 5V regulator, up to 3A output current, can be powered from battery through VIN terminal
Reserved I2C control pins, allows to work with other control boards Comes with development resources and manual (examples in BCM2835, wiringPi, and python)
21,99 € EN AMAZON
Waveshare
Waveshare 2.13inch e-Paper Display Hat 250x122 Resolution SPI E-Ink Screen Electronic Paper Module with Embedded Controller Partial Refresh for Raspberry Pi Zero/Zero W/Zero WH for pwnagotchi Project
Envío gratis
79
CALIDAD BUENA
VER EN AMAZON
Amazon.es
#7
▼ Mostrar más
▲ Mostrar menos
V4 Latest Version.Note:Please check the verison and use the corresponding demo code in wiki.No backlight, keeps displaying last content for a long time even when power down
Ultra low power consumption, basically power is only required for refreshing
Compatible with Raspberry Pi Zero/Zero W/Zero WH/2B/3B/3B+,Jetson Nano,,but incompatible with Netatmo
SPI interface, for connecting with other controller boards like Arduino/Nucleo, etc. Onboard voltage translator, compatible with 3.3V/5V MCUs
Comes with development resources and manual (examples for Raspberry/Jetson Nano/Arduino/STM32)
20,99 € EN AMAZON
innomaker
InnoMaker DAC Mini Hat PCM5122 - Tarjeta de audio para Raspberry Pi 5/4/3B+/Zero 2W, HiFi Shield 384 kHz/32bit DAC con RCA y salida de 3,5 mm
Envío gratis
74
CALIDAD BUENA
VER EN AMAZON
Amazon.es
#8
▼ Mostrar más
▲ Mostrar menos
Ajuste perfecto para tablas compactas: especialmente diseñado para Raspberry Pi Zero, Zero W, Zero 2 y Zero 2 W, se ajusta perfectamente sin sobrevivir. Totalmente compatible con todos los modelos de 40 pines, incluyendo Pi 5, Pi 4 y 3B+.
Amplia compatibilidad con software: funciona instantáneamente con todos los sistemas de reproductores de música populares como Volumio, Moode, RuneAudio, OSMC, PiCorePlayer y Max2Play, así como con sistemas operativos estándar como Raspberry Pi OS, Debian y Ubuntu.
【Combinación de amplificador y DAC de alto rendimiento】Equipado con PCM5122 DAC de alta resolución de 32 bits/384 kHz para una claridad excepcional y el amplificador de auriculares TPA6133 con salida de 2,1 Vrms para un sonido potente y limpio.
Doble salida dorada: ofrece tanto conectores RCA RCA (izquierda/derecha) como una salida de auriculares de 3,5 mm para conexiones de alta calidad a altavoces, amplificadores o auriculares directamente desde el Raspberry Pi.
Sonido excelente, valor inmejorable: ofrece un nivel de ruido extremadamente bajo y una calidad de sonido de audio que desafía los costosos DAC independientes – una increíble relación calidad-precio para los entusiastas del audio.
28,99 € EN AMAZON
Waveshare
Waveshare SIM7600G-H 4G Hat (B) for Raspberry Pi Supports LTE Cat-4 4G/3G/2G GNSS Positioning Global Band
Envío gratis
74
CALIDAD BUENA
VER EN AMAZON
Amazon.es
#9
▼ Mostrar más
▲ Mostrar menos
4G HAT FOR RASPBERRY PI,Enabling LTE Cat-4 4G / 3G / 2G Communication & GNSS Positioning,Based on SIM7600G-H, Global Band
Suitable For Raspberry Pi / PC,Dedicated Pogo Pin For Connecting With Raspberry Pi Zero/Zero W Without Extra USB Cable General Purpose MicroUSB Connector For Other Raspberry Pi Boards Or PC
Global Band 4G / 3G / 2G Support,Up To 50Mbps Uplink And 150Mbps Downlink For 4G Network
USB HUB Feature,Onboard USB HUB Chip With USB2.0/1.1 Compliant, Providing 2x USB-A Connector And 1x USB Solder Pad
GNSS Positioning,Supports GPS, BeiDou, Glonass, LBS Base Station Positioning; Telephoto Call & SMS Support,Making Telephoto Call Or Sending SMS By AT Commands, With Onboard Audio Jack
96,99 € EN AMAZON
Waveshare
Waveshare Raspberry Pi 1.3inch IPS LCD Display Hat, 240x240 Pixels with Embedded Controller, Communicating Via SPI Interface
Envío gratis
69
CALIDAD BUENA
VER EN AMAZON
Amazon.es
#10
▼ Mostrar más
▲ Mostrar menos
Please note:fbtft_device and flexfb are gone in 5.4.fbtft_device was removed because the gpio code had been reworked without fixing up fbtft_device so it didn't work.
This is an IPS LCD display HAT for Raspberry Pi, 1.3inch diagonal, 240x240 pixels, with embedded controller, communicating via SPI interface.Standard Raspberry Pi connectivity, compatible with Raspberry Pi Zero/Zero W/Zero WH/2B/3B/3B+
IPS screen, wide viewing angle, better display High definition in small size 1x joystick, 3x pushbuttons, handy and useful
Comes with development resources and manual (examples for Raspberry Pi)
Driver: ST7789;Display color: RGB, 65K color;perating voltage: 3.3V
20,99 € EN AMAZON
raspberry pi zero
pi zero hat
hat raspberry pi
raspberry pi hat
carcasa raspberry pi zero
raspberry pi zero usb
raspberry pi 3 zero
raspberry pi w zero
raspberry pi zero w
raspberry pi zero wifi