Raspberry Pi Hat
Los 10 mejores productos de julio de 2025
Última actualización:
27 de julio de 2025
Freenove
Freenove Breakout Board for Raspberry Pi 5 / 4B / 3B+ / 3B / 3A+ / 2B / 1B+ / 1A+ / Zero 2 W/Zero W/Zero, Terminal Block Shield Hat with Pin Header, GPIO Status LED
Envío gratis
98
CALIDAD MÁXIMA
VER EN AMAZON
Amazon.es
#1 GANADOR
▼ Mostrar más
▲ Mostrar menos
Compatible Models: Raspberry Pi 5 / 4B / 3B+ / 3B / 3A+ / 2B / 1B+ / 1A+ / Zero 2 W / Zero W / Zero (Note: NOT compatible with 500 / 400)
GPIO Status LED: LED on if GPIO outputs / inputs high level, LED off if GPIO outputs / inputs low level
Independent LED: The status LED is driven by the chip instead of the GPIO so the GPIO will not be affected
Terminal Block and Header: Connect to all pins of Raspberry Pi's 40-pin GPIO header, 2.54 mm (0.1 inch) pitch
Pin Name: The BCM numbering name of each pin is printed next to it
11,95 € EN AMAZON
innomaker
InnoMaker Rasp Pi HiFi DAC Hat PCM5122 Audio Sound Card Expansion Board for Raspberry Pi 4 3 B B+ Pi Zero W
Envío gratis
98
CALIDAD MÁXIMA
VER EN AMAZON
Amazon.es
#2
▼ Mostrar más
▲ Mostrar menos
The HiFi DAC Hat compatible with Raspberry Pi Zero, Zero W, 3B, 3B+, Pi 4 with the 40-pin connector. Connects directly to the Raspberry Pi board, no additional cables required, no soldering. Easy to get more beautiful and fantastic sound by this RPI+DAC HiFi suits.
Absolutely perfect to support all Raspberry Pi music playback system, like OSMC, Max2Play, RuneAudio, Volumio, Moode, PiCorePlayer, PiMusicBox, OpenELEC, Debian, Ubuntu etc. Support playing music from a hard disk or over the network. Support DSD over PCM(DOP) mode.
Class-leading stereo audio DAC PCM5122, sample rates up to 384-KHz/32-Bit. Paired with stereo high fidelity headphone amplifier TPA6133. Provides 2.1Vrms ground-centered outputs coupled with Film capacitor.
On-board a pair of gold plated RCA (LEFT &Right) jacks and a 3.5mm high-end headphone jack output, allow you free to play your music through Raspberry Pi to another terminals.
Comes with software, document and friendly technology support. For more information, please refer to our wiki(view the link on color page comes with the goods).
34,99 € EN AMAZON
Waveshare
RS485 Can Hat para Raspberry Pi 4B/3B+/3B/2B/B+/A+/Zero/Zero W/WH, Permitir la Comunicación a Larga Distancia a Través de la Función RS485/CAN
Envío gratis
95
CALIDAD EXCELENTE
VER EN AMAZON
Amazon.es
#3
▼ Mostrar más
▲ Mostrar menos
RS485 CAN HAT for Raspberry Pi 4B/3B+/3B/2B/B+/A+/Zero/Zero W/WH, with standard Raspberry Pi 40PIN GPIO extension header
CAN function, onboard CAN controller MCP2515 via SPI interface, onboard transceiver SN65HVD230
RS485 function, controlled via UART, half-duplex communication, supports automatic TX/RX control without programming, onboard transceiver SP3485
Onboard TVS (Transient Voltage Suppressor), effectively suppress surge voltage and transient spike voltage in the circuit for RS485 transceiving, lightningproof & anti-electrostatic
Reserved control pins, allows to work with other control boards, comes with development resources and manual (examples in wiringPi/python)
19,52 € EN AMAZON
Geekworm
Geekworm X1001 PCIe to M.2 NVMe SSD Shield para Raspberry Pi 5
Envío gratis
91
CALIDAD DISTINGUIDA
VER EN AMAZON
Amazon.es
#4
▼ Mostrar más
▲ Mostrar menos
【Compatibility】only for Raspberry Pi 5 16GB / 8GB / 4GB (NOT included)
【Matching Case (NOT included)】P579 Case (ASIN: B0CRB3DT5M); Or P579 Case with Official Active Cooler (ASIN: B0CT4P893Q)
【M2 Key-M NVMe SSD Supported】Support M.2 KEY-M NVMe SSD 2230/2242/2260/2280 length installation.【IMPORTANT】DON'T use NVMe SSD with Phison controller, please refer to: https://wiki.geekworm.com/X1001#Important_Notes
【How to Power】Use 5Vdc +/-5%, 5A to power via Raspberry Pi 5, and Pi 5 will power X1001 via FFC PCIe ribbon. Recommend to use Geekworm PD 27W power adapter (ASIN: B0CP8SRXSC)
【Packing List】1 x X1001 Shield, 1x Accessories Pack
16,00 € EN AMAZON
Waveshare
Waveshare PoE Hat (C) For Raspberry Pi 3B+/4B, 802.3af/at Power-Sourcing Equipment Required
Envío gratis
88
CALIDAD DISTINGUIDA
VER EN AMAZON
Amazon.es
#5
▼ Mostrar más
▲ Mostrar menos
PoE HAT (C) is a 802.3af/at-compliant Power Over Ethernet accessory(with Standard Pi 40PIN GPIO Header) for the Raspberry Pi 3B+/4B
By using this small HAT and some proper 802.3af/at-compliant power sourcing equipments, it is possible to provide both network connection and power supply for your Pi in only one Ethernet cable. Fully isolated switched-mode power supply (SMPS)
While providing stable power for Raspberry Pi, there's also a USB-A port for powering extra external device
Onboard high speed active cooling fan, better heat dissipation
24,99 € EN AMAZON
Waveshare
Waveshare UPS Hat (C) for Raspberry Pi Zero 5V Uninterruptible Power Supply Multi Battery Protection Circuits(Battery is Not Included)
Envío gratis
82
CALIDAD FIABLE
VER EN AMAZON
Amazon.es
#6
▼ Mostrar más
▲ Mostrar menos
Power Your Pi Zero Seamlessly From Power Connection OR The Backup Batteries. Supports Recharging And Regulated 5V Output At The Same Time, I2C Monitoring.
Onboard spring pogo pins for connecting with Raspberry Pi Zero series boards. Li-po battery recharge chip, with dynamic path management, more stable power supply.
Voltage boost chip, providing regulated 5V power output. I2C bus communication, monitoring the battery voltage, current, power, and remaining capacity in real time.
Multi battery protection circuits: over charge/discharge protection, over current protection, and short circuit protection, more safe and stable.
Recharging indicator for monitoring the battery operating status.
28,99 € EN AMAZON
Raspberry Pi
Raspberry Pi 5 Kit AI Hat+
80
CALIDAD BUENA
VER EN AMAZON
Amazon.es
#7
▼ Mostrar más
▲ Mostrar menos
Contiene un acelerador de inferencia de red neuronal capaz de 13 tera-operaciones por segundo (TOPS)
Totalmente integrado en la pila de software de cámara de Raspberry Pi
La almohadilla térmica preinstalada entre el módulo y HAT+ extiende el calor a través de los componentes, mejorando el rendimiento
Cumple con las especificaciones Raspberry Pi HAT+
Se suministra con cabezal apilable, espaciadores y tornillos de 16 mm para permitir el montaje en Raspberry Pi 5 con el enfriador activo Raspberry Pi en su lugar
107,49 € EN AMAZON
Waveshare
Waveshare NVMe PCIe To M.2 Hat+ Adapter with PoE, Compatible with Raspberry Pi 5, Supports NVMe Drive Protocol 2230/2242 M.2 Solid State Drive and 802.3af/at Network Standard, with Cooling Fan
Envío gratis
78
CALIDAD BUENA
VER EN AMAZON
Amazon.es
#8
▼ Mostrar más
▲ Mostrar menos
PCIe To M.2 with PoE HAT,designed for Raspberry Pi 5, supports IEEE 802.3af/at network standard. Adapter for NVMe Protocol M.2 Solid State Drive, High-speed Reading/Writing.
Improves reading/writing speed of your Pi. Note: Only supports the NVMe Protocol Solid State Drives.
Based on 16PIN PCIe Interface of Raspberry Pi 5. Standard Raspberry Pi 40PIN GPIO stackable header, allows connecting other HATs
Onboard Dual LED Indicators,easy to monitor the Working Status. Compatible With 2230/2242 Size M.2 Solid State Drive. Supports Gen2 and Gen3 Modes, Supports Booting PI5 From Solid State Drive.
Providing both network connection and power supply for your Raspberry Pi in one cable
5V header provides up to 4.5A output (MAX 25W for 12V+5V total output power). be able to power extra devices while providing stable power to Raspberry Pi.
️Rich WiKi Resources️ We provide official Wiki resources, please contact us for more information.
35,99 € EN AMAZON
Waveshare
Waveshare WM8960 Audio Hi-Fi Sound Card Hat for Raspberry Pi Stereo CODEC Play Record I2S Interface
Envío gratis
71
CALIDAD BUENA
VER EN AMAZON
Amazon.es
#9
▼ Mostrar más
▲ Mostrar menos
Raspberry Pi connectivity, compatible with Raspberry Pi Zero/Zero W/Zero WH/2B/3B/3B+. Can be used for the latest bookworm 64 bit system (i.e. the latest driver requires a 64 bit system).
Integrates WM8960 low power stereo CODEC, communicates via I2S interface
Integrates dual high-quality MEMS silicon Mic, supports left & right double channels recording, nice sound quality
Onboard standard 3.5mm earphone jack, play music via external earphone Onboard dual-channel speaker interface, directly drives speakers
Supports sound effects such as stereo, 3D surrounding, etc.
25,99 € EN AMAZON
GeeekPi
GeeekPi P33 M.2 NVME M-Key PoE+ Hat for Raspberry Pi 5, with Official Raspberry Pi 5 Active Cooler, Support M.2 NVMe SSD 2230 2242 2260 2280
Envío gratis
67
CALIDAD BUENA
VER EN AMAZON
Amazon.es
#10
▼ Mostrar más
▲ Mostrar menos
【Compatibilidad】Este kit incluye a P33 M.2 NVME M-Key PoE+ HAT y un oficial Raspberry Pi Active Cooler, especialmente diseñado para el último modelo Raspberry Pi 5, un rendimiento óptimo y compatibilidad.
【Alta velocidad NVMe SSD Support】Los soportes de tabla de HAT M.2 NVMe SSDs para accesos y almacenamiento de datos rápidos.
【M.2 Interface】Utiliza la interfaz PCIe para comunicación de alto rendimiento entre SSD y Raspberry Pi.
【PoE HAT Design】Fácil entrega de energía con alimentación a través de Ethernet, eliminando la necesidad de cables adicionales.
【802.3at PoE Support】Requires a 802.3at PoE switch to provide up to 30W of power, ensuring sufficient power for demanding aplications.
【Máxima entrega de energía】 Capaz de delivering up to 25W at 5,1 V/4,5 A, adecuado para alimentar tanto la Raspberry Pi como el NVMe SSD.
39,99 € EN AMAZON
hat raspberry pi
raspberry pi 3 hat
raspberry pi hat sata
raspberry pi sata hat
raspberry pi hat m2
raspberry pi sense hat
sense hat raspberry pi
hat raspberry pi 5
raspberry pi 5 hat
raspberry pi poe hat