E-ink Display 32
Los 10 mejores productos de julio de 2025
Última actualización:
11 de julio de 2025
Waveshare
Waveshare ESP32-S3 1.8inch AMOLED Touch Display Development Board, 32-bit LX7 Dual-Core Processor, 368x448, Accelerometer&Gyroscope Sensor, ESP32 with Display, Support 3.7V Li Battery(Not Included)
Envío gratis
98
CALIDAD MÁXIMA
VER EN AMAZON
Amazon.es
#1 GANADOR
▼ Mostrar más
▲ Mostrar menos
Equipped with ESP32-S3R8 Xtensa 32-bit LX7 dual-core processor, up to 240MHz main frequency. Supports 2.4GHz Wi-Fi (802.11 b/g/n) and Bluetooth 5 (LE), with onboard antenna. Built in 512KB of SRAM and 384KB ROM, with onboard 8MB PSRAM and an external 16MB Flash memory. Type-C connector, improving device compatibility, easier to use
Onboard 1.8inch AMOLED display for clear color picture display, 368 x 448 resolution, 16.7M color. Built-in SH8601 display driver and FT3168 capacitive touch chip, using QSPI and I2C communication respectively, effectively saving the IO resources. Onboard PWR and BOOT programmable buttons for easy custom function development
Onboard QMI8658 6-axis IMU (3-axis accelerometer and 3-axis gyroscope) for detecting motion gesture, counting steps, etc. Onboard PCF85063 RTC chip, powered by main Lithium battery through AXP2101 chip, with reserved RTC battery pads for connecting a backup battery, ensuring RTC function during the replacement of the main battery. Onboard 3.7V MX1.25 Lithium battery recharge/discharge header, Support 3.7V Lithium battery(NOT Included)
Reserved pads of 7 x GPIO, 1 x I2C, 1 x UART, and 1 x USB interface, for connecting peripherals and debugging. Onboard TF card slot for extended storage and fast data transfer, suitable for applications such as data recording and media playback, simplifying circuit design
Adopts AXP2101 IC for efficient power management, supports multiple voltage outputs, battery charging, battery management, and battery life optimization, etc. Adopts AMOLED screen, featuring advantages of high contrast, wide viewing angle, rich colors, fast response, thinner design, and low power consumption, etc
41,99 € EN AMAZON
Tonysa
5.76 Android E Reader | E Ink HD 198ppi Display | Modo de Luz Cálida y Oscura Ajustables | Epub/PDF/Mobi Soporte | Bluetooth 5.0 | WiFi | Incluye Estuche Protector (Grey)
96
CALIDAD SUPERIOR
VER EN AMAZON
Amazon.es
#2
▼ Mostrar más
▲ Mostrar menos
Pantalla de 5.76 pulgadas: el lector E cuenta de una pantalla HD de 5.76 pulgadas con resolución 920x680 y 198ppi, utilizando tecnología de papel E, que ofrece papel como de página rápida para una experiencia de lectura auténtica.
Comodidad versátil: con 24 temperatura de color ajustable y un contraste mejorado, el lector de libros E es ideal para la lectura interior y exterior, proporcionando comodidad incluso bajo la luz solar directa.
Lectura personalizable: características como un modo oscuro con texto sobre un fondo negro y una luz frontal personalizada hacen que la lectura de varios formatos como PDF, EPUB, MOBI, TXT, FB2, DOC, AZW, AZW3.
Conectividad expansiva: ejecutándose en un código abierto para el system Android, el lector E admite WiFi, Bluetooth e instala una amplia gama de aplicaciones de terceros, facilitando una rica variedad de opciones de lectura y escucha.
Almacenamiento amplio: equipado con 1 GB de RAM y 32 GB de ROM, junto con soporte para el almacenamiento expandible de hasta 1 TB, el lector de libros electrónicos asegura que puede llevar una vasta biblioteca de libros.
123,40 € EN AMAZON
Waveshare
Waveshare 2.9 Inch E-Paper Display Panel Module Kit 296x128 Resolution E-Ink Electronic Screen for for Raspberry Pi/Jetson Nano/Arduino/STM32 Support Partial Refresh SPI Interface
Envío gratis
92
CALIDAD EXCELENTE
VER EN AMAZON
Amazon.es
#3
▼ Mostrar más
▲ Mostrar menos
This is an E-Ink display module, 2.9inch, 296x128 resolution, with embedded controller, communicating via SPI interface, supports partial refresh.Comes with development resources and manual (examples for Raspberry Pi/Jetson Nano/Arduino/STM32)
Due to the advantages like ultra low power consumption, wide viewing angle, great effect under sunlight, it is an ideal choice for applications such as shelf label, industrial instrument, and so on.
No backlight, keeps displaying last content for a long time even when power down
Ultra low power consumption, basically power is only required for refreshing
SPI interface, for connecting with controller boards like Raspberry Pi/Arduino/Nucleo, etc.Onboard voltage translator, compatible with 3.3V/5V MCUs
24,99 € EN AMAZON
xicoolee
7.5inch E-Paper Display 800x480 Resolution, SPI Interface E-Ink Screen for Raspberry Pi, Arduino, STM32, ESP32 - Monochrome Hat with Partial Refresh & Open-Source Code
89
CALIDAD DISTINGUIDA
VER EN AMAZON
Amazon.es
#4
▼ Mostrar más
▲ Mostrar menos
High-Resolution E-Ink Display – 7.5-inch monochrome E-Paper screen with 800x480 resolution, delivering crisp text and graphics for e-books, digital signage, industrial labels, and IoT projects.
Fits Raspberry Pi & Multi-Board – Designed for Raspberry Pi 40-pin GPIO (all models) and pre-configured SPI interface for Arduino, STM32, and ESP32 integration. Level-shifting chip supports 3.3V/5V microcontrollers.
SPI Communication & Partial Refresh – Optimized SPI interface minimizes pin usage and enables fast full/partial refresh modes to reduce power consumption and screen flickering.
Open-Source Development Support – Includes ready-to-use C/Python code for Raspberry Pi and Arduino/STM32/ESP32 examples for drawing shapes, text, and images. Ideal for DIY and industrial prototyping.
Versatile E-Paper Applications – Perfect for e-readers, smart price tags, logistics labels, conference nameplates, electronic memos, and energy-efficient digital billboards.
53,11 € EN AMAZON
ASUS
ASUS ProArt Display PA32UCXR - Monitor Profesional de 32", 4K UHD (3840 x 2160), Mini-LED, 99% Adobe RGB, 97% DCI-P3, ΔE < 1, Thunderbolt 4, VESA DisplayHDR 1400, ColourSpace, Soporte ergonómico
82
CALIDAD FIABLE
VER EN AMAZON
Amazon.es
#5
▼ Mostrar más
▲ Mostrar menos
32 pulgadas con Mini LED con retroiluminación, con atenuación local de 2.304 zonas que proporciona 1.600 nits de brillo máximo y 1.000 nits de brillo sostenido en toda la pantalla
El colorímetro incorporado admite calibración manual y automática, así como el conjunto de software profesional de calibración por hardware Calman y Light Illusion ColourSpace CMS
Profundidad de color real de 10 bits, 99% Adobe RGB, 97% DCI-P3 de gama cromática amplia
Soporta múltiples formatos HDR (Dolby Vision, HDR-10, HLG) presenta una experiencia realista y flexibilidad
Amplia conectividad que incluye dos puertos Thunderbolt 4 USB-C con suministro de energía de 90 W, DisplayPort, HDMI, concentrador USB para una mayor flexibilidad
3.577,48 € EN AMAZON
PocketBook
PocketBook InkPad Color 3 Libro Electrónico 7.8" 32GB Azul Tormenta
Envío gratis
80
CALIDAD BUENA
VER EN AMAZON
Amazon.es
#6
▼ Mostrar más
▲ Mostrar menos
Producto original de marca.
Dos años de garantía ante defectos de fábrica.
Display.size : 7.8 inches
285,00 € EN AMAZON
Waveshare
Waveshare 7.5 Inch E-Paper Display Hat Module V2 Kit 800x480 Resolution 3.3v/5v E-Ink Electronic Screen with Embedded Controller SPI Interface Compatible with Raspberry Pi/Jetson Nano/Arduino/STM32
Envío gratis
79
CALIDAD BUENA
VER EN AMAZON
Amazon.es
#7
▼ Mostrar más
▲ Mostrar menos
Note:Version 2 please use corresponding demo code in wiki.This is an E-Ink display HAT for Raspberry Pi, 7.5inch, 800×480 resolution, with embedded controller, communicating via SPI interface. Due to the advantages like ultra low power consumption, wide viewing angle, clear display without electricity, it is an ideal choice for applications such as shelf label, industrial instrument, and so on.
No backlight, keeps displaying last content for a long time even when power down.Ultra low power consumption, basically power is only required for refreshing
Standard Raspberry Pi 40PIN GPIO extension header, supports Raspberry Pi series boards, Jetson Nano. SPI interface, for connecting with other controller boards like Raspberry/Arduino/Nucleo, etc.
Onboard voltage translator, compatible with 3.3V/5V MCUs.Comes with development resources and manual (examples for Raspberry Pi/Jetson Nano/Arduino/STM32)
Note that you cannot use Partial refresh all the time, you should full refresh e-paper regularly, otherwise, ghost problem will get worse even damage.Please set the e-Paper to sleep mode or power off it directly, otherwise, the e-Paper is damaged because of working in high voltage for long time. You need to update the content of three-color e-Paper at least one time every 24h to avoid from burn-in problem.
69,99 € EN AMAZON
Waveshare
Waveshare 2.13inch e-Paper Display Hat 250x122 Resolution SPI E-Ink Screen Electronic Paper Module with Embedded Controller Partial Refresh for Raspberry Pi Zero/Zero W/Zero WH for pwnagotchi Project
Envío gratis
75
CALIDAD BUENA
VER EN AMAZON
Amazon.es
#8
▼ Mostrar más
▲ Mostrar menos
V4 Latest Version.Note:Please check the verison and use the corresponding demo code in wiki.No backlight, keeps displaying last content for a long time even when power down
Ultra low power consumption, basically power is only required for refreshing
Compatible with Raspberry Pi Zero/Zero W/Zero WH/2B/3B/3B+,Jetson Nano,,but incompatible with Netatmo
SPI interface, for connecting with other controller boards like Arduino/Nucleo, etc. Onboard voltage translator, compatible with 3.3V/5V MCUs
Comes with development resources and manual (examples for Raspberry/Jetson Nano/Arduino/STM32)
20,99 € EN AMAZON
Waveshare
Waveshare ESP32-S3 Development Board, 32-bit LX7 Dual-Core Processor, Integrates GC9A01 Display Driver Chip, with 1.28inch IPS Round LCD, 240×240 Resolution, Supports WiFi
Envío gratis
73
CALIDAD BUENA
VER EN AMAZON
Amazon.es
#9
▼ Mostrar más
▲ Mostrar menos
Equipped with Xtensa庐 32-bit LX7 dual-core processor, up to 240MHz main frequency. Built in 512KB of SRAM and 384KB ROM, with onboard 2MB PSRAM and an external 16MB Flash memory
Supports 2.4GHz Wi-Fi (802.11 b/g/n) and BT5 (BLE), with onboard antenna. Type-C connector, keeps it up to date, easier to use
Onboard 1.28inch LCD display, round IPS panel, 240x240 resolution, 65K color. Onboard QMI8658 6-axis IMU (3-axis accelerometer and 3-axis gyroscope) for detecting motion gesture. Onboard 3.7V lithium battery recharge/discharge header and GPIO headers
Supports flexible clock, module power supply independent setting, and other controls to realize low power consumption in different scenarios
Integrated with USB serial port full-speed controller, GPIO pins allow flexibly configuring pin functions
25,99 € EN AMAZON
qingping
Qingping Temperature and Humidity Monitor Mi Home Version, Indoor Digital Bluetooth Thermometer Hygrometer for Home Room with E Ink Display …
Envío gratis
70
CALIDAD BUENA
VER EN AMAZON
Amazon.es
#10
▼ Mostrar más
▲ Mostrar menos
【E Ink Display】Readings on the display are so clear, just like printed characters on real paper. So you can know the temperature and humidity at a glance, from different angles in the room.
【Accurate Measurements】The built-in Swiss-made sensor responds with accurate real-time measurements. The measurement range of temperature is 32 ~122°F (0 ~ 50 °C) and for humidity, 0% ~ 99.9%RH (under no condensation circumstances). You can switch between Fahrenheit and Celsius by pressing the button on the back of the product. The device is not waterproof or dustproof, please do not place this product in an environment with humidity higher than 90% for long term use.
【Check Data Remotely and Enable Automation】The product supports Mi Home app. You can check temperature/humidity data remotely, and you can set automation with other Mi Home environmental appliances. A Mi Home Bluetooth Gateway, such as a Qingping Bluetooth Gateway (sold separately) is needed for remote access/automation/historical data collection.
【Intelligent Design】Multiple mounting options: 1) With the magnetic wall sticker, you can easily attach it to a wall, or detach it; 2) Open the stand on the back of the product, you can place it on a desktop; 3) You can attach it on an iron surface (because it has built-in magnets). It can be a pretty decoration for the living room, bedroom, greenhouse, or anywhere you want.
【Low power consumption】Powered by the CR2430 button cell, the product has up to 8~12 months of battery life in normal indoor environments (data provided by Qingping lab).
29,31 € EN AMAZON
e ink display
e-ink display
display 32
#1 GANADOR
